32-10 Brush Cutter

Welded construction of side frame member and formed plate cross-members.

62,000 lbs. (28123.2 kg)

Caterpillar®C9.3B 335 hp @ 2200 rpm Tier IV Final

Closed-loop variable displacement axial piston pump driving a fixed displacement axial piston motor. Maximum travel speed is 35 mph with full-time four-wheel drive.

Hydrostatic transmission drives a 4-speed shift on the go gearbox. Front and rear automotive type axles with automatic positive locking differentials are driven through cardan shafts with slip joints.

28 inch cast steel wheels are bolted to axle hubs. 4-wheel clasp brakes are axle mounted. Service brakes are air applied and spring released. Parking brakes are spring applied and air released. Suspension system utilizes coil springs.

Air compressor, engine oil-lubricated, air-cooled; 13 cu. ft free air volume @ 2200 rpm; system pressure 100 psi; 613 cu. in. air tank. Air is supplied to service brakes through a pressure reducing valve with pressure gauge. Parking brake is set by means of an electrically activated air dump valve. System is also equipped with dual-tone air horns and a safety relief valve.

The engine drives a triple pump drive through a clutch. Two triple pumps power the cutter motors and the cutter head control circuits.

24 volts dc negative ground;150 amp alternator; color coded and numbered wiring.

The cab accommodates two operators (one for each cutterhead). Adequate height is provided for standing at entry door and rear section. Each operator has a set of foot pedals for controlling direction. The cab is equipped with heater, air conditioner, and a pressurization unit. Cab side walls are double wall construction (1/4” A514 over 11 ga.) with Lexan®marguard windows.

Fuel tank: 110 gallons. Hydraulic tank: 100 gallons.

Booms can rotate a 10 ft. wide double disk cutterhead outboard up to 30 ft. from rail centerline and 45° up/40° down from horizontal.

The Brushcutter has a turntable and can be turned manually.