12-12 Tie/Bridge Crane

Welded construction, lower frame is structural steel and 1” (25.4 mm) thick steel plate for the slewing ring support. Upper deck is structural steel and formed deck plates. Frame covered by Five (5) Year Warranty. Oversize 467/8 inch diameter slewing ring rated for80,000 ft-lb. Remote grease fittings for slewing ring and axle bearings. 8-channel 6,000 psi hydraulic swivel is accessible from upper deck.

Caterpillar C4.4, 131 hp @ 2200 rpm, Tier IV final

3” (76 mm) diameter solid axles with chain drive from separate hydraulic motors driving both axles. Travel speed: 20 mph (32 km/hr). Two (2) propel drive motors for quicker response in work mode. #100 drive chain with hardened tooth sprockets.

Hydrostatic propel pressure compensated piston type pump direct coupled to engine. Deck rotation by hydraulic motor through gearbox. Hydraulic oil is filtered through a 100 mesh (145 micron) suction screen and 10 micron return line filter. Manifold-type stack valves for improved serviceability. Remote oil cooler accessible from ground level with dual electric cooling fans. Electric emergency pump.

24 volt DC negative ground, 100 amp alternator, color coded and numbered wiring

Large enclosed cab with 99.5 cubic foot capacity. Ergonomically designed seat. Large front windshield with an unobstructed view of boom operation through full range of motion.Boom and deck rotate controlled by hydraulic pilot-pressure bottom-ported joystick controls located on operator seat.Self-contained hydraulically driven air conditioner/heater/pressurizer unit mounted on rear wall of cab.

16” (406 mm) cast steel wheels. External, individual composite brake shoes applied directly on the vertical centerline of wheel tread. Service brakes are spring applied, hydraulic released. Emergency/parking brakes are spring applied, hydraulic released.

Fuel: 75 gal. (284 liters), Hydraulic: 70 gal. (265 liters)

23,000 lbs

Ultra-wide 32 inch (813 mm) spread base root boom mount. GV-12 grapple rotator. Single tie grapple.